12v Brushless DC Motor Built-in Controller CCW 12vdc
This is a compact 12vdc brushless motor that outputs 100W of power with a controller integrated to the
motor.  2 wires for the power lines and 3 thinner wires for connecting to a potentiometer.  Motor has a
reverse polarity protection in case that an user accidentally wires the power lines incorrectly.  When
reverse polarity occurs, a fuse will burn out and all the user has to do is to replace the fuse and the
motor is good as new.  Motor is a Hall-sensor type.  Specifications are listed below:

Motor's Diameter:  3.8 inches
Motor's Body Length:  2.5 inches
Shaft Diameter:  8mm with one flat surface (D shaft)
Shaft Length:  2 inches
Housing Construction:  Die-cast aluminum
Mounting:  Rear mount with 2-hole, 3-hole and 4-hole mounting patterns
Rated Voltage:  13.8 VDC
Rated Output:  100 Watts
Speed at Rated Output:  2700 RPM
No-load Speed:  4000 RPM
Speed Control Type:  3 wires for 10k ohm potentiometer, yellow to wiper, red to return, black to ground
Bearings:  2 ball bearings
Magnet Material:  Rare-earth magnet (Neodymium)
Rotation:  Counter-Clock-wise
Protections:  Current limiter, reverse-polarity, load-dump
Wiring:  Black to negative; red to positive